Blown-In Insulation — Southwestern Ontario

Blown-In Attic
Insulation in Ontario

The most effective way to upgrade your attic insulation to Ontario's R-50 target. Fast, minimally invasive, and highly effective for both new and existing homes across Southwestern Ontario.

What is Blown-In Attic Insulation?

Blown-in insulation (also called loose-fill insulation) is installed using a blowing machine that pumps loose fibreglass or cellulose fibres into attic spaces and enclosed wall cavities. The material flows around obstructions, fills irregular cavities, and achieves consistent coverage that is difficult to replicate with batt insulation — making it the gold standard for attic insulation upgrades in Ontario.

Benefits of Blown-In Attic Insulation

Blown-in insulation is fast to install, minimally invasive, and highly effective at reducing heat loss through your attic — the single biggest source of energy loss in most Ontario homes. It achieves Ontario's recommended R-50 attic insulation target more easily than batt insulation and naturally fills around rafters, blocking, and ceiling fixtures that are difficult to insulate otherwise. Many homeowners see a noticeable reduction in heating and cooling costs within the first season.

Topping Up vs. Full Replacement

If your existing attic insulation is below R-30 (the minimum for many older Ontario homes), blown-in insulation can be added directly on top to reach the R-50 target. We assess the existing insulation, check for air leakage points and vapour barrier issues, and then blow in the appropriate depth of new material. In some cases — such as when insulation has become wet or contaminated — full removal and replacement is recommended.

Blown-In for Enclosed Wall Cavities

Blown-in insulation is also used to upgrade the insulation in existing finished walls without opening the drywall. Small holes are drilled into the exterior or interior surface, insulation is blown into each stud cavity, and the holes are then patched. This is an ideal solution for older homes in London, Woodstock, Chatham-Kent and surrounding communities where walls were built with minimal or no insulation.

Frequently Asked Questions

How many inches of blown-in insulation do I need in Ontario?

To achieve R-50 (recommended by Natural Resources Canada and Ontario Building Code for new construction), you typically need 16–18 inches of blown-in fibreglass or approximately 14–16 inches of cellulose insulation.

Can blown-in insulation be installed over existing insulation?

Yes, in most cases. As long as the existing insulation is dry, not contaminated, and a proper vapour barrier is in place, new blown-in insulation can be added directly on top to increase the total R-value.

How long does blown-in insulation last?

Fibreglass blown-in insulation can last 80–100 years without significant degradation when kept dry. Cellulose may settle slightly over time, which is accounted for in the initial installation depth.

(519) 550-6368